ESP Home

[Juergen]

esphome:
  name: co2
  friendly_name: CO2

esp8266:
  board: esp01_1m

# Enable logging
logger:

# Enable Home Assistant API
api:
  encryption:
    key: "LSvuWpCuxsP9gPFWIreNFSDZ4yvhlPMzrKsILV9qSnQ="

ota:
  password: "8bfc5dfa222020bd88526e2707a90e6c"

wifi:
  ssid: "Juergen Ap2"
  password: "KonBanWa#f0"

  # Enable fallback hotspot (captive portal) in case wifi connection fails
  ap:
    ssid: "Co2 Fallback Hotspot"
    password: "konbanwa"

captive_portal:

# Service für  HA
#services:
#  - service: mhz19_calibrate_zero
#    then:
#      - mhz19_calibrate_zero: sens1

# serielle Schnittstelle
uart:
  rx_pin: GPIO4
  tx_pin: GPIO5
  baud_rate: 9600


sensor:
  - platform: mhz19
    co2:
      name: "MH-Z19 CO2 Value"
      id: co2val
      on_value_range:
        - below: 1200
          then:
            - switch.turn_on: green_pin
            - switch.turn_off: yellow_pin
            - switch.turn_off: red_pin
        - above: 1200
          then:
            - switch.turn_off: green_pin
            - switch.turn_on: yellow_pin
            - switch.turn_off: red_pin   
        - above: 1800
          then:
            - switch.turn_off: green_pin
            - switch.turn_off: yellow_pin
            - switch.turn_on: red_pin
    temperature:
      name: "MH-Z19 Temperature"
    update_interval: 60s
    automatic_baseline_calibration: False
    id: sens1

# LED konfig
switch:
  - platform: gpio
    pin: GPIO12
    id: red_pin
    name: "CO2 rot"
  - platform: gpio
    pin: GPIO14
    id: yellow_pin
    name: "CO2 gelb"
  - platform: gpio
    pin: GPIO16
    id: green_pin
    name: "CO2 grün"

beim #service - block gibt es einen Fehler " Service unbekannt " was ist da falsch ?

 

[azrael783]

Hi,

du musst den Service Teil unter api: schieben. Steht auch so in der Doku:

api:
  services:
    - service: mhz19_calibrate_zero
      then:
        - mhz19.calibrate_zero: my_mhz19_id

 

[Juergen]

danke